|
Hydraulic Milling Cutter ETH
Hydraulic milling cutters from our ETH series can be mounted
to any suitably sized hydraulic excavator. This milling
cutter range is uncomplicated, and compact and maintenance-free
except for oil changes. It may be used on hydraulic excavators
of any make with a suitable weight and engine.
 The
milling cutter consists mainly of an Eickhoff gearbox and
a pair of cross cutter heads equipped with conical tools.
It is powered by a hydraulic engine that is supplied by
the excavator hydraulics with compressed oil.
The milling cutter is easily mounted to the hydraulic
excavator, using an adapter. Once the milling cutter is
mounted to the adapter and rotated by 90°, it may be used
to mill narrow ditches with a minimum width of 70 cm.
 Areas
of application
- Civil engineering and road construction
Excavation of ditches with a minimum width of 70 cm
Excavation of cellars and foundation work
Milling of asphalt
- Demolition, dismantling of buildings
Milling of concrete and brickwork
Part-demolition while protecting the remaining part of
the building
- Tunnelling and mining
Tunnelling, profiling, redevelopment, brush-down
Extraction of minerals
- Hydraulic engineering
Lowering of navigable water ways
Milling of trenches for pile planking
Milling of culverts in river bed
- Low-noise applications
Wherever other mining equipment (e.g. hydraulic hammers)
is too noisy
model |
capacity,
KW |
operating
weight of excavator,
tons |
ETH
30 - the ideal mountable excavator device
for canal and tunnel construction |
ETH 30 |
100 |
min. 20 |
ETH
50 - for demanding applications in hard rock
and concrete demolition |
ETH 50 |
150 |
min. 30 |
ETH
200 - for cost-effective large-scale excavations
in many areas, also underwater |
ETH 200 |
270 |
min. 60 |
Contact:
Mr. Michael Walkowiak
Phone: +(49)234-975 2031
Fax: +(49)234-975 2040
Mail: mwalkowiak@eickhoff-bochum.de
|
|
